How to install Upgrade Kit
How to install the VEKTA Pro Upgrade Kit
Before you start
- You'll need the USB-C cable and the USB-A adapter that came with your VEKTA.
- Unplug the VEKTA from any device.
- The most delicate part is the microphone connector. Always hold the plug, never the wire, and don't force it.
- Installing the kit as described in this guide doesn't void your VEKTA's warranty.
Install the kit
Step 1: Remove the screws
Use the included Torx key to remove the two screws from the housing (turn anticlockwise). Keep them in a small container so they don't roll away.
Step 2: Slide the board out
Gently slide the board out of the housing. It may be tight, so pull firmly but carefully: the microphone is still connected.
Step 3: Unplug the microphone
Unplug the microphone from the board. Pull the plug, not the wire.
Step 4: Plug the microphone into the new board
Align the connector with its socket and push it straight in until it's fully seated. If it doesn't go in, check its orientation. Never force it, and don't press on the battery.
Step 5: Place the new board in the housing
The board stays in place on its own, no glue needed. Check that the buttons line up with their openings and that the microphone wire isn't trapped.
Step 6: Close the housing
Use the two new screws from the kit and tighten them (turn clockwise) until snug. Don't overtighten them: this can crack the housing.
Charge your mask
Your mask is now a VEKTA Pro. Charge it fully before you use it for the first time.
- Plug a USB-C cable into the mask.
- Plug the other end into a charger or a computer.
A full charge takes about 2 hours. While it's charging, the mask's LED alternates yellow and green. When it's fully charged, the LED blinks green and turns off.
Watch the video
Prefer to watch? Here's the full installation, step by step.
Still have questions?
Visit the Support page or email us at support@metadox.pro. Please include your order number so we can find your details quickly.