How to install Upgrade Kit

How to install the VEKTA Pro Upgrade Kit

How to install the VEKTA Pro Upgrade Kit

Before you start

  • You'll need the USB-C cable and the USB-A adapter that came with your VEKTA.
  • Unplug the VEKTA from any device.
  • The most delicate part is the microphone connector. Always hold the plug, never the wire, and don't force it.
  • Installing the kit as described in this guide doesn't void your VEKTA's warranty.

Install the kit

Step 1: Remove the screws

Use the included Torx key to remove the two screws from the housing (turn anticlockwise). Keep them in a small container so they don't roll away.

Removing the two screws with the Torx key

Step 2: Slide the board out

Gently slide the board out of the housing. It may be tight, so pull firmly but carefully: the microphone is still connected.

Sliding the board out of the housing

Step 3: Unplug the microphone

Unplug the microphone from the board. Pull the plug, not the wire.

Unplugging the microphone from the board

Step 4: Plug the microphone into the new board

Align the connector with its socket and push it straight in until it's fully seated. If it doesn't go in, check its orientation. Never force it, and don't press on the battery.

Plugging the microphone into the new board

Step 5: Place the new board in the housing

The board stays in place on its own, no glue needed. Check that the buttons line up with their openings and that the microphone wire isn't trapped.

Placing the new board in the housing

Step 6: Close the housing

Use the two new screws from the kit and tighten them (turn clockwise) until snug. Don't overtighten them: this can crack the housing.

Tightening the two screws

Charge your mask

Your mask is now a VEKTA Pro. Charge it fully before you use it for the first time.

  1. Plug a USB-C cable into the mask.
  2. Plug the other end into a charger or a computer.

A full charge takes about 2 hours. While it's charging, the mask's LED alternates yellow and green. When it's fully charged, the LED blinks green and turns off.

Watch the video

Prefer to watch? Here's the full installation, step by step.

Still have questions?

Visit the Support page or email us at support@metadox.pro. Please include your order number so we can find your details quickly.

返回網誌

還有問題嗎?請聯絡我們的支援團隊